Your Key to Wireless Energy Management Systems
The Entuit Door / Window Sensor helps provide energy savings for an area by detecting when a door or window opens or closes. It is a wireless solar-powered sensor that can be used on its own to detect the open and closed status of entry doors or windows, or it can be paired with Entuit's occupancy sensor to accurately detect whenever someone enters or exits a room. The sensor is easy to install on door and window frames, and virtually anything indoors that opens and closes.
Sends wireless message to other devices whenever a door or window opens or closes
Harvests ambient solar energy to power the sensor and send wireless communication
Mounts easily on standard doors or windows
Works with motion sensors to track room
occupancy and temperature control
Supplemental battery option for extreme low-light fail over
Discreet and low-proﬁle
Take a moment to plan for the sensor’s successful operation and optimal communication with other system components. Remove the sensor from its packaging and place it under a strong light to charge it for installation.
Ensure the location provides consistent and
Install according to the alignment requirements
Determine which sensor proﬁle is appropriate,
see the Linking section
Consider the construction materials in the space
and obstacles that may interfere with RF signals
Power Supply Solar harvesting, supplemental battery option
Transmission Range 80 ft. (25 m)
Radio Frequency 902 MHz
Light Required to 15 lux for 6 actuations/hour
Maintain Operation 50 lux for 30 actuations/ hour
lOO lux for 60 actuations/hour
Charge Time to Setup 2.7 hours @ 10 lux
3.7 minutes @ 200 lux
Charge Time to 21 hours @ 2OO lux (after startuP)
Fully Charge 42 hours @ 2OO lux (cold start)
Fully Charged Operating 174 hours: heartbeat only
Life in Darkness 67 hours @ 10 actuations/hour
10 hours @ 1OO actuations/hour
Maximum Sensor Gap O.25 inch (6.4 mm)
Sensor Dimensions 3.15” L x O.83” W x O.59” D
( 8.O cm x 2.1 cm x 1.5 cm)
Magnet Dimensions 3.15” L x O.47” W x O.5” D
(8.Ocm x 1.2cm x 1.3cm)
Total Weight 0.97 oz. (27.5 g)
Environment -Indoor use only
- 32° to 131° F (0° to 55° C)
- 5% to 95% relative humidity
Agency Compliance FCC and I.C.
The proximity of the magnet to the sensor is important for proper detection. The alignment arrows on the sensor and the magnet must point to each other and the gap between them must not exceed .25 inch (6.4 mm) in any direction.
© Copyright 2017 Entuit, Inc.
email - email@example.com
IN PARTNERSHIP WITH ENTUIT, INC.
300 International Dr., Suite 100
Williamsville, NY 14221